There may be some technical problems in the engraving machine during use. Let me tell you how to solve it.
When the software is opened, the computer prompts "Failed to open the card, please check the card".
Solution:
1. Check if the driver of the board is installed or replace the card with a PCI slot;
2. Reinstall the two data cables to check for broken needles.
3. There is a problem with the board, and the board is replaced.
Question 2: Prompt when opening the software: three-axis alarm, initialization error number four.
Solution:
1. Check if the two data cables of the computer and the machine are connected;
2. Check if the fuse of the adapter plate in the control box is burned out and replace the fuse;
3. Check if the 5V12V power supply is working normally.
Question 3: There is a misalignment during engraving, or the size is wrong.
Solution:
1. Check if the path of the engraving software is correct or not;
2. Check the clearance of the screw and whether the fastening screws of the polished rod are loose;
3. Check that the software parameters are set correctly.
Question 4: When the X-axis is walking a certain section, the Z-axis does not raise the knife. Press it up and go down.
Solution:
1. Check if the Z-axis motor is running normally, the power and the current of the drive;
2. Check the Z-axis motor line for poor contact or intermediate disconnection.
Question 5: The spindle motor does not rotate or reverse.
Solution:
1. Check the settings of the parameters of the inverter;
2. Whether the signal line of the inverter is reversed.
Question 6: There is a sickle phenomenon.
Solution:
1. The Z-axis motor has insufficient power and the coupling is loose;
2. The current of the Z-axis driver is too small, or the signal line is wrong.
Question 7: When the software is turned on, the axis turns off.
Solution:
1. Problems with the drive or poor contact with the computer output signal line;
2. Poor motor line contact.
Question 8: A limit occurs during the engraving process.
Solution:
1. Check if the engraving path exceeds the engraving range;
2. The soft limit of parameter setting in V6.02 software.
Question 9: The machine is not powered when it is turned on.
Solution:
1. Check if the start button wire is connected and the button is burnt out;
2. Check if the AC contactor is shorted or burned out.
Question 10: The axis only goes in one direction when the button is moving.
Solution:
1. Check if the optical line is working properly and its line is in good contact;
2. Check the motor circuit for solder joints.
Question 11: The sending software does not open properly, and the engravings are malformed.
Solution:
1. Reinstall new systems and software;
2. Check if the X, Y axis screw and screw are loose;
3. Carving knife has problems
